Reply to thread

Message: <blockquote data-quote="ChaseinBass" data-source="post: 8566272" data-attributes="member: 655848"><p>I would weld it in and if you needed to move it wider you would just grind the welds off and move it .  Correct me if I am wrong but  once you get your port size close in planning you would only be changing the length not the overall  port size ?  Well I guess if you start out with partition a little wide - as wide as your sub baffle will allow so you would have room to make port wider too ? And as big as your builds are I would mirror the angle iron on the back of it so it fits around the perimeter of the shell to stiffen it up more.</p></blockquote><p></p>

Top