Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
Advice needed
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Jpar28" data-source="post: 8660995" data-attributes="member: 675962"><p>I have a boss audio 2 channel amp that’s 450w rms at 4 ohm bridged and a single alpine type s 12” dual voice coil 4ohm sub in a 1.6 cubic foot slot potted box. I can wire the sub at 2 ohm witch overloads the amp or at 8 ohm witch is where I have it now. It runs good now but lacks the thunder lol. My question is, is there anyway to know how much power I’m putting to the sub with it wired at 8 ohm? Any recommendations on a good amp for this sub? I’m considering getting another type s 12 and going back to a sealed box. Would the amp I currently have be enough power to run two of these subs? It’s 600 watt rms by two channel at 2 ohms. Thanks for any answers</p></blockquote><p></p>
[QUOTE="Jpar28, post: 8660995, member: 675962"] I have a boss audio 2 channel amp that’s 450w rms at 4 ohm bridged and a single alpine type s 12” dual voice coil 4ohm sub in a 1.6 cubic foot slot potted box. I can wire the sub at 2 ohm witch overloads the amp or at 8 ohm witch is where I have it now. It runs good now but lacks the thunder lol. My question is, is there anyway to know how much power I’m putting to the sub with it wired at 8 ohm? Any recommendations on a good amp for this sub? I’m considering getting another type s 12 and going back to a sealed box. Would the amp I currently have be enough power to run two of these subs? It’s 600 watt rms by two channel at 2 ohms. Thanks for any answers [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
Advice needed
Top
Menu
Home
Refresh