Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Amplifiers
Advice needed for a kenwood amp.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Slayer16102" data-source="post: 8720081" data-attributes="member: 676644"><p>Thank you, I will have it tested at a shop.</p><p>So the voltage I am running is 28.28v @ 400 watts converts to 14.286 amps on a 110 amp alternator.</p><p>Should the stock alternator on this be able to pull that power and keep the charging system running properly or is their too much draw on the system at 400 watts?</p><p></p><p>Correction to the audio system I originally listed it as a rockford R|2 its actually a Rockford P3SD2-12 2 ohm running at 400w RMS with a supplied voltage of 28.28v which draws a current of 14.286 amps. Keep in mind that my amp has 3 40 Amp fuses on it some I'm not sure how that plays into the current draw.</p></blockquote><p></p>
[QUOTE="Slayer16102, post: 8720081, member: 676644"] Thank you, I will have it tested at a shop. So the voltage I am running is 28.28v @ 400 watts converts to 14.286 amps on a 110 amp alternator. Should the stock alternator on this be able to pull that power and keep the charging system running properly or is their too much draw on the system at 400 watts? Correction to the audio system I originally listed it as a rockford R|2 its actually a Rockford P3SD2-12 2 ohm running at 400w RMS with a supplied voltage of 28.28v which draws a current of 14.286 amps. Keep in mind that my amp has 3 40 Amp fuses on it some I'm not sure how that plays into the current draw. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Amplifiers
Advice needed for a kenwood amp.
Top
Menu
What's new
Forum list
