Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
About IB Enclosures
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Blackout67" data-source="post: 8909379" data-attributes="member: 683415"><p>Thinking about doing an IB setup for my Mustang. My first question would be how hard is it to seal these holes in the rear deck? A cheap option would be multiple layers of cardboard sealed with duct tape with CLD over top, but not sure if that would be adequate. Maybe 1/8 ABS plastic, tape, and CLD? Does it need to be 100 percent completely sealed? </p><p></p><p>2nd I know IB is a more SQ oriented build that requires much less power, what kind of power and size/amount of drivers would be necessary to get a good 130ish DBs? I know thats a variable answer question but not sure if anyone else with IB setups could advise their general experience. Also, Subsonic filter: unneeded or necessary?</p></blockquote><p></p>
[QUOTE="Blackout67, post: 8909379, member: 683415"] Thinking about doing an IB setup for my Mustang. My first question would be how hard is it to seal these holes in the rear deck? A cheap option would be multiple layers of cardboard sealed with duct tape with CLD over top, but not sure if that would be adequate. Maybe 1/8 ABS plastic, tape, and CLD? Does it need to be 100 percent completely sealed? 2nd I know IB is a more SQ oriented build that requires much less power, what kind of power and size/amount of drivers would be necessary to get a good 130ish DBs? I know thats a variable answer question but not sure if anyone else with IB setups could advise their general experience. Also, Subsonic filter: unneeded or necessary? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
About IB Enclosures
Top
Menu
What's new
Forum list
