Reply to thread

Message

<blockquote data-quote="J.D. Nichols" data-source="post: 8712774" data-attributes="member: 680538">Ok I have a 1 ohm 8 inch Mtx right now that is being run by a 1000w amp that can run 400 watts x 1 bridged output at 4 ohms and 165 watts RMS x 2 at 4 ohms. 200 watts x 2 at 2 ohms. . And had 2 of the 1ohm Mtx running on two channels. So both had their own channel turns out that didn&#039;t work and like I said I&#039;m only running one of the speakers and now that speaker just stops playing once and a while and the amp is not turning off and not going into protection mode. I&#039;m worried that I while have to replaced that speaker already and till I can find a solution I&#039;ve took the power cord out of the amp so the speaker is not running. I&#039;m guessing that I will have to replace that speaker cause its just not meant for that amp so I&#039;ve looking and I found the kicker comprt that runs at 1000w max, 500w rms and at 4 ohms. And I just can&#039;t figure out if that will work.</blockquote>

[QUOTE="J.D. Nichols, post: 8712774, member: 680538"] Ok I have a 1 ohm 8 inch Mtx right now that is being run by a 1000w amp that can run 400 watts x 1 bridged output at 4 [B]ohms [/B]and 165 watts RMS x 2 at 4 [B]ohms[/B]. 200 watts x 2 at 2 [B]ohms[/B]. . And had 2 of the 1ohm Mtx running on two channels. So both had their own channel turns out that didn't work and like I said I'm only running one of the speakers and now that speaker just stops playing once and a while and the amp is not turning off and not going into protection mode. I'm worried that I while have to replaced that speaker already and till I can find a solution I've took the power cord out of the amp so the speaker is not running. I'm guessing that I will have to replace that speaker cause its just not meant for that amp so I've looking and I found the kicker comprt that runs at 1000w max, 500w rms and at 4 ohms. And I just can't figure out if that will work. [/QUOTE]

Verification