Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
A few novice questions I need help with and setup advice.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="audiobaun" data-source="post: 8760980" data-attributes="member: 634282"><p>You are only going to be able to get only about 1/2 the performance of that sub rather than going to the 1 ohm set up that will give you a little more deeper/ lower sub stage running @ 1 ohm. If you have the room and get a Dual sub enclosure with same sub, you can run 2 Ohms wired correctly and that amp would do very well on both. Id return that amp if you are going to run that single sub. the other amplifiers will give you a little more power options along with options if you decide to swap to a larger RMS sub with power on tap to do so and perform nicely with a tuned enclosure. At this point with that Alpine amplifier... you will need to wire that sub @ 4 ohms to use that amp </p><p><a href="https://www.the12volt.com/caraudio/subwoofer-wiring-diagrams.asp?Q=1&I=22" target="_blank">https://www.the12volt.com/caraudio/subwoofer-wiring-diagrams.asp?Q=1&I=22</a></p></blockquote><p></p>
[QUOTE="audiobaun, post: 8760980, member: 634282"] You are only going to be able to get only about 1/2 the performance of that sub rather than going to the 1 ohm set up that will give you a little more deeper/ lower sub stage running @ 1 ohm. If you have the room and get a Dual sub enclosure with same sub, you can run 2 Ohms wired correctly and that amp would do very well on both. Id return that amp if you are going to run that single sub. the other amplifiers will give you a little more power options along with options if you decide to swap to a larger RMS sub with power on tap to do so and perform nicely with a tuned enclosure. At this point with that Alpine amplifier... you will need to wire that sub @ 4 ohms to use that amp [URL]https://www.the12volt.com/caraudio/subwoofer-wiring-diagrams.asp?Q=1&I=22[/URL] [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
A few novice questions I need help with and setup advice.
Top
Menu
Home
Refresh