Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
Car Audio Build Logs
94 Mitsu Eclipse, sx12, 2.0 cu.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="944g37" data-source="post: 5632353" data-attributes="member: 604313"><p>The only thing i wish i did was go with a 15 since i couldnt use the box i already had anyway. The box is the biggest "recommended" volume for a SX 12 and anything beyond what you guys say and what the manufacturers say is not an area im looking to go. I do wish it had more low end frequency response. But who finishes their setup and goes "yup, just enough low end". And after seeing the voltage at the amp go into the 11's on a low note im not worried about it until i upgrade my charging system for the sake of my amplifiers. If i could sell this setup for a profit (which i bet i could being that i bought it all dirt cheap) i would build the same style setup but with a SX 15 and a single zx1000.1. Other than that it pounds beyond anything anyone in this little **** hole town i live in has ever heard and when i dial down the sub output and put some slipknot on it sounds like im standing front row at their concert.</p><p></p><p>As far as the MDF im not at the level of building where im willing to buy sheets of birch yet, 3/4 MDF works just fine as long as i get a sheet thats not so ****ed warped next time!</p></blockquote><p></p>
[QUOTE="944g37, post: 5632353, member: 604313"] The only thing i wish i did was go with a 15 since i couldnt use the box i already had anyway. The box is the biggest "recommended" volume for a SX 12 and anything beyond what you guys say and what the manufacturers say is not an area im looking to go. I do wish it had more low end frequency response. But who finishes their setup and goes "yup, just enough low end". And after seeing the voltage at the amp go into the 11's on a low note im not worried about it until i upgrade my charging system for the sake of my amplifiers. If i could sell this setup for a profit (which i bet i could being that i bought it all dirt cheap) i would build the same style setup but with a SX 15 and a single zx1000.1. Other than that it pounds beyond anything anyone in this little **** hole town i live in has ever heard and when i dial down the sub output and put some slipknot on it sounds like im standing front row at their concert. As far as the MDF im not at the level of building where im willing to buy sheets of birch yet, 3/4 MDF works just fine as long as i get a sheet thats not so ****ed warped next time! [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Car Audio Build Logs
94 Mitsu Eclipse, sx12, 2.0 cu.
Top
Menu
Home
Refresh