80 pound 3" coil motor for sale

[Papermaker85 5,000+ posts]

Item(s) for Sale:

going to sell my prototype motor. i got 2 9500I motors to build 2 18s and i have no room for the woofer. its very similar to the nightshade v3 motor with a few differences. its similar in size so to speak. its ridiculously ******

Item(s) Description/Condition: in good condition. sub is fully built right now in good condition. has the TI basket. takes my 3500 @ 0.5 ohm as long as i'm not clipping it heavy all day long.

Price:

400 for hte woofer as is(in working order)

350 for hte motor

550 if you want me to build something for you

Shipping and Miscellaneous Item Information: you cover shipping and handling( just hte motor is about 40 bucks and fully built about 90)

Item Pictures:

(List pictures in this section, 1st picture should be your username/date if you have less than 10 positive feedbacks with the i-Trader system or less than 10 references that you have sold to in the past. (These must be listed in your signature, or a link provided to a feedback thread listing these references)).

Click to read more...

 

[Papermaker85 5,000+ posts]

Nobody? Could do a sick build with this motor.

 

[Papermaker85 5,000+ posts]

300 plus shipping for a monster woofer easily comparable to 650$

 

[ciaonzo 5,000+ posts]

She's nice, you could do a sick underhung with that top plate. How many layers is the gap able to accommodate?

 

[Papermaker85 5,000+ posts]

its a pretty tight gap on the smaller side. you could do a 6 layer single copper coil that would handle 1500 or so but good luck getting one wound without breaking the bank .lol the OD is 3.24 if i recall. Id is 2.97. i'll have to remeasure.

next driver will be SPL based. noone cares about low inductance low reactantce highly linear drivers(100% of the b/l with 22mm xmax each way) and low power compression(i've put over 4500 clipped to it)! they just want OUTPUT..

 

[Papermaker85 5,000+ posts]

Bump. ****** woofer for half the price of something you would buy..