Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
6 speakers in a 4 channel setup with mixed impedances
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="spikes527" data-source="post: 8430405" data-attributes="member: 667452"><p>Hey all I'm new to these forums so I hope I'm in the right place... anyway I currently have a 4 speaker system hooked up to my Crunch PZX1200.4. The speakers are 2 ohms so that's 300w per speaker. (even though the speakers are only rated for 150w rms at 2 ohms, but that's another story) I have a pair of 6x9 kickers that are rated for 150w rms at 4 ohms. My question is can I wire my 4 2ohm speakers to one channel (either in a series, parallel, or series-parallel) and the 2 4ohm speakers to the other channel safely? Sorry I know that's a long one! Any help would be greatly appreciated.</p></blockquote><p></p>
[QUOTE="spikes527, post: 8430405, member: 667452"] Hey all I'm new to these forums so I hope I'm in the right place... anyway I currently have a 4 speaker system hooked up to my Crunch PZX1200.4. The speakers are 2 ohms so that's 300w per speaker. (even though the speakers are only rated for 150w rms at 2 ohms, but that's another story) I have a pair of 6x9 kickers that are rated for 150w rms at 4 ohms. My question is can I wire my 4 2ohm speakers to one channel (either in a series, parallel, or series-parallel) and the 2 4ohm speakers to the other channel safely? Sorry I know that's a long one! Any help would be greatly appreciated. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
6 speakers in a 4 channel setup with mixed impedances
Top
Menu
Home
Refresh