Reply to thread

Message

<blockquote data-quote="showtm490" data-source="post: 8741297" data-attributes="member: 640157">Thank you.The DD D5.1500 looks like an awesome amp.&nbsp; The nearest dealer is 1.5hrs a way but worth looking at.&nbsp; 4ohm (Ch 1-4) 125x4 / (CH 5) 680x12ohm (CH 1-4) 180x4 / (CH 5) 1000x11ohm (CH 5) 1500x1I didn&#039;t factor in needing a signal processor which is built into the AudioControl D5.1300 for $1100.After reading more I&#039;m going to just run front speakers with a sub.&nbsp; My rear doors I&#039;ll leave just for fill.&nbsp; With that being said I can spend what I was on the rears for better fronts.&nbsp; Checking out Crutchfield these fit my doors.&nbsp; The tweeters I&#039;ll need to decide to mount either in the A pillar, the door or where the 3.5&#039;s goes in the dash.&nbsp; Or would you still run the Kenwood 3.5&#039;s in the factory dash locations off the head unit?Audiofrog G60SJL Audio C2-600Morel Maximo Ultra 502Thank you again for the help.</blockquote>

[QUOTE="showtm490, post: 8741297, member: 640157"] Thank you. The DD D5.1500 looks like an awesome amp. The nearest dealer is 1.5hrs a way but worth looking at. 4ohm (Ch 1-4) 125x4 / (CH 5) 680x1 2ohm (CH 1-4) 180x4 / (CH 5) 1000x1 1ohm (CH 5) 1500x1 I didn't factor in needing a signal processor which is built into the AudioControl D5.1300 for $1100. After reading more I'm going to just run front speakers with a sub. My rear doors I'll leave just for fill. With that being said I can spend what I was on the rears for better fronts. Checking out Crutchfield these fit my doors. The tweeters I'll need to decide to mount either in the A pillar, the door or where the 3.5's goes in the dash. Or would you still run the Kenwood 3.5's in the factory dash locations off the head unit? Audiofrog G60S JL Audio C2-600 Morel Maximo Ultra 502 Thank you again for the help. [/QUOTE]

Verification