Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
4awg & 8awg usage?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="mavster" data-source="post: 3144924" data-attributes="member: 577999"><p>Ok, right now I have a 4awg wire from my battery (was hell to run in the first place)....</p><p></p><p>currently my equipment consists of a Nakamichi PA-506...so the 4awg ran directly to the amp...</p><p></p><p>But now I have a PA-1002 on the way, the distro block I have takes a 4 awg and spits out 4 x 8awgs. Is 8awg sufficient enough on a 2 or 3 foot max run?</p><p></p><p>Also have an EQ on the way...as well...</p><p></p><p>Should I give the PA506 1 x 8awg, and pa-1002 2 x 8awg and the EQ 1 x 8awg?</p><p></p><p>keep in mind, the pa506, only the first 4 channels will be used, the sub channels will be turned off.</p><p></p><p>Thanks</p></blockquote><p></p>
[QUOTE="mavster, post: 3144924, member: 577999"] Ok, right now I have a 4awg wire from my battery (was hell to run in the first place).... currently my equipment consists of a Nakamichi PA-506...so the 4awg ran directly to the amp... But now I have a PA-1002 on the way, the distro block I have takes a 4 awg and spits out 4 x 8awgs. Is 8awg sufficient enough on a 2 or 3 foot max run? Also have an EQ on the way...as well... Should I give the PA506 1 x 8awg, and pa-1002 2 x 8awg and the EQ 1 x 8awg? keep in mind, the pa506, only the first 4 channels will be used, the sub channels will be turned off. Thanks [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
4awg & 8awg usage?
Top
Menu
What's new
Forum list
