Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
CarAudio.com Classifieds
Car Audio Classifieds
450/4
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="CrazyKenKid" data-source="post: 5893220" data-attributes="member: 579796"><p>congrat on getting a ring!! and i though i would post some specs for you!</p><p></p><p>Channels 1 and 2:</p><p></p><p>Rated Power (stereo mode): 150W RMS x 2 @ 1.5 ohm-4 ohm (11V-14.5V)</p><p></p><p>Rated Power (bridged mode): 300W RMS x 1 @ 3 ohm-8 ohm (11V-14.5V)</p><p></p><p>Channels 3 and 4:</p><p></p><p>Rated Power (stereo mode): 75W RMS x 2 @ 1.5 ohm-4 ohm (11V-14.5V)</p><p></p><p>Rated Power (bridged mode): 150W RMS x 1 @ 3 ohm-8 ohm (11V-14.5V)</p><p></p><p>Peak Power Output 900 watts approx.</p><p></p><p>Differential-Balanced Input Topology: (2 pairs of inputs)</p><p></p><p>Channels 1 and 2 Crossover:</p><p></p><p>Fully-variable (50 Hz-5 KHz), selectable-slope LP or HP (12 or 24 dB per octave)</p><p></p><p>Channels 3 and 4 Crossover:</p><p></p><p>Fully-variable (50 Hz-5 KHz), selectable-slope LP or HP (12 or 24 dB per octave)</p><p></p><p>THD at Rated Power:</p><p></p><p>S/N Ratio*: &gt;108.5 dB below rated power</p><p></p><p>Frequency Response: 5 Hz-30 KHz (+0, -1dB)</p><p></p><p>Damping Factor: &gt;200 @ 4 ohm per ch./50 Hz</p><p></p><p>Input Range: switchable from 200mV-2V RMS to 800mV-8V RMS</p><p></p><p>Preamp Output: 2-channel (Pass-through with selectable input sourcing)</p><p></p><p>Bass EQ: +6 dB (variable boost up to +15 dB with Remote Bass Option)</p><p></p><p>Infrasonic Filter (Channels 1&amp;2 only): defeatable 24dB/octave at 30 Hz</p><p></p><p>Speaker output connections: accept up to 8ga. wire</p><p></p><p>+12V and Ground connections: accept up to 4ga. Wire</p><p></p><p>Fuse Rating: 60A</p><p></p><p>Dimensions: 13.4"L x 9.25"W x 2.36"H</p><p></p><p>RMS Power Range : 150-300 Watts</p><p></p><p>Number Of Channels: 4</p><p></p><p>Maximum Power: 900 Watts</p><p></p><p>Low Frequency response: 5 Hz</p><p></p><p>High Frequency Response: 30000 Hz</p><p></p><p>Built In Crossovers: Yes</p><p></p><p>Channel Separation: Yes</p></blockquote><p></p>
[QUOTE="CrazyKenKid, post: 5893220, member: 579796"] congrat on getting a ring!! and i though i would post some specs for you! Channels 1 and 2: Rated Power (stereo mode): 150W RMS x 2 @ 1.5 ohm-4 ohm (11V-14.5V) Rated Power (bridged mode): 300W RMS x 1 @ 3 ohm-8 ohm (11V-14.5V) Channels 3 and 4: Rated Power (stereo mode): 75W RMS x 2 @ 1.5 ohm-4 ohm (11V-14.5V) Rated Power (bridged mode): 150W RMS x 1 @ 3 ohm-8 ohm (11V-14.5V) Peak Power Output 900 watts approx. Differential-Balanced Input Topology: (2 pairs of inputs) Channels 1 and 2 Crossover: Fully-variable (50 Hz-5 KHz), selectable-slope LP or HP (12 or 24 dB per octave) Channels 3 and 4 Crossover: Fully-variable (50 Hz-5 KHz), selectable-slope LP or HP (12 or 24 dB per octave) THD at Rated Power: S/N Ratio*: >108.5 dB below rated power Frequency Response: 5 Hz-30 KHz (+0, -1dB) Damping Factor: >200 @ 4 ohm per ch./50 Hz Input Range: switchable from 200mV-2V RMS to 800mV-8V RMS Preamp Output: 2-channel (Pass-through with selectable input sourcing) Bass EQ: +6 dB (variable boost up to +15 dB with Remote Bass Option) Infrasonic Filter (Channels 1&2 only): defeatable 24dB/octave at 30 Hz Speaker output connections: accept up to 8ga. wire +12V and Ground connections: accept up to 4ga. Wire Fuse Rating: 60A Dimensions: 13.4"L x 9.25"W x 2.36"H RMS Power Range : 150-300 Watts Number Of Channels: 4 Maximum Power: 900 Watts Low Frequency response: 5 Hz High Frequency Response: 30000 Hz Built In Crossovers: Yes Channel Separation: Yes [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
CarAudio.com Classifieds
Car Audio Classifieds
450/4
Top
Menu
What's new
Forum list
