4 nighshade 18s yukon xl build 155+ 16v minus the bullshit

[TnT_Sounds 10+ year member]

I personally would do common chamber.

I think so too.

 

[gtbike900 10+ year member]

if i do one chamber i might as well do 200 inches and shrink from there

 

[sub-FATHER 10+ year member]

could u stop please...u will have him tuned to the moon if u keep it up
80

his port length will be around 35 inchs long at 27 hz with 16 cubes per foot on his box. if the port is smaller his port will be longer to tune that low.

 

[gtbike900 10+ year member]

ports going to be 22 inches long though tuned to 32

 

[TnT_Sounds 10+ year member]

if i do one chamber i might as well do 200 inches and shrink from there

Seems easier I think.

 

[gtbike900 10+ year member]

easy to shrink hard to add lol

 

[sub-FATHER 10+ year member]

if i do one chamber i might as well do 200 inches and shrink from there

the seperate chambers offers stability and lower impedance rise. \

and when your done with the box you have two seperate chambered boxes you can sell instead of destroying it.

its easier to run your amps and make sure your amps are strapped to 2 subs

 

[gtbike900 10+ year member]

and if i do 2 chambers i need to do less bracing

 

[gtbike900 10+ year member]

im still not sure though 2 ppl say chambered 2 say common camber

 

[sub-FATHER 10+ year member]

im still not sure though 2 ppl say chambered 2 say common camber

what do you want? do what you want! just base it off of ideas and tweek it to make it your own. be inovative and create something of yours.

 

[basebalz13 10+ year member]

his port length will be around 35 inchs long at 27 hz with 16 cubes per foot on his box. if the port is smaller his port will be longer to tune that low.

once again you are wrong, will you please just stop postin

the smaller the port area, the shorter the port has to be. the more port area the longer the ports will be. jus stick on the smaller side 80 sq for 8 cubes is a little on the small side, build a test box n try it out

 

[gtbike900 10+ year member]

well then if im going with what i think 2 chambers would be the best and im going with 100 inches of port do to the advice i have been givin if ports to big i can always shrink it and cut down the lenght to retune

 

[sub-FATHER 10+ year member]

once again you are wrong, will you please just stop postin

the smaller the port area, the shorter the port has to be. the more port area the longer the ports will be. jus stick on the smaller side 80 sq for 8 cubes is a little on the small side, build a test box n try it out

sorry 27 inches long with 16 ft box with 160 cubes

and 200 cubes would be 34 inches long for 27 hz...

port noise is an issue with that many subs also.

 

[sub-FATHER 10+ year member]

feed them subs airspace since you have the juice and you will realize that 95 percent of these clowns should just sit back and watch.

 

[basebalz13 10+ year member]

GTbike, refrain from listening to anythng sub2weeker says concerning port area and box size, and youll be good to go //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif