Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
CarAudio.com Classifieds
Car Audio Wanted
3d box design crossfire xsv2
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="98GCLimited" data-source="post: 8110485" data-attributes="member: 615917"><p>2200w is barely going to get that thing moving. I think they take 3krms+ to start doing their thing well.</p><p></p><p>I had my xs v2 15 in a 5 cube box with 16x5 (80sq in) port tuned to around 32hz powered by an rd 1750.1 @ .7ohm and it was decent but wanted more power. Upgraded to a saz3000 @ .7 ohm and it was pretty ridiculous for a single 15 but I think could have used a little smaller box on the 3k and could have taken more than the 3k in a smaller box.</p><p></p><p>3.5-5 cubes If I did it over again (sold the sub and amp) I would probably go with 4.25 cubes and shrink it a little if I needed to with big 45s or something.</p></blockquote><p></p>
[QUOTE="98GCLimited, post: 8110485, member: 615917"] 2200w is barely going to get that thing moving. I think they take 3krms+ to start doing their thing well. I had my xs v2 15 in a 5 cube box with 16x5 (80sq in) port tuned to around 32hz powered by an rd 1750.1 @ .7ohm and it was decent but wanted more power. Upgraded to a saz3000 @ .7 ohm and it was pretty ridiculous for a single 15 but I think could have used a little smaller box on the 3k and could have taken more than the 3k in a smaller box. 3.5-5 cubes If I did it over again (sold the sub and amp) I would probably go with 4.25 cubes and shrink it a little if I needed to with big 45s or something. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
CarAudio.com Classifieds
Car Audio Wanted
3d box design crossfire xsv2
Top
Menu
Home
Refresh