Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Equipment
Speakers
3 way active door setup help
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="djdilliodon!" data-source="post: 8776033" data-attributes="member: 684299"><p>here is what I would do. Attached is the pic you took of the entire door panel. You see the line I put arrows pointing too? I’d cut on that line to get rid of everything below it. 1/2” mdf mounted to the door skin use bolts and washers and I’d use mdf rings and build them out using dowels or 1x2 pine etc. Staple the fiberglass cloth over it to give me my shape I’m going for and start glassing it. If you know how to work with fiberglass this ain’t hard to do at all and you can actually make it look nice just by covering it with carpet. You will easily get the most airspace this way and you can run dual 8”, 7”, 6.5” etc drivers if you so please! Now what drivers? Gotta settle on the size, with a budget of $300 the choices IMO are pretty wide especially since it’s an enclosure involved now.</p></blockquote><p></p>
[QUOTE="djdilliodon!, post: 8776033, member: 684299"] here is what I would do. Attached is the pic you took of the entire door panel. You see the line I put arrows pointing too? I’d cut on that line to get rid of everything below it. 1/2” mdf mounted to the door skin use bolts and washers and I’d use mdf rings and build them out using dowels or 1x2 pine etc. Staple the fiberglass cloth over it to give me my shape I’m going for and start glassing it. If you know how to work with fiberglass this ain’t hard to do at all and you can actually make it look nice just by covering it with carpet. You will easily get the most airspace this way and you can run dual 8”, 7”, 6.5” etc drivers if you so please! Now what drivers? Gotta settle on the size, with a budget of $300 the choices IMO are pretty wide especially since it’s an enclosure involved now. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Equipment
Speakers
3 way active door setup help
Top
Menu
Home
Refresh