Reply to thread

Message: <blockquote data-quote="req" data-source="post: 3523277" data-attributes="member: 555713">**** it.remove the stereo, tuck the harness somewhere (there is no sense wire) and run your own power and ground. there is a distrobution block above the break pedal with ring terminal type connections on it. use a multimeter, turn can on and test for 12v (and rev the engine to see if it changes just in case) turn it off, and test the ones that read 12~14 volts. find one that turns off, i want to say its the one on the far right hand side. connect +12v to your yellow headunit wire, and the switched (car off 0v car on 12v) to the red wire on your headunit, and ground the black wire.all done.</blockquote>

Top