Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Builds
Car Audio Build Logs
2000 Jeep Wrangler
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="GoldCountryCA" data-source="post: 8885921" data-attributes="member: 690466"><p>It’s settled. I purchased my speakers from CDT again, because my ram sounds great. Took it a step further and also decided to try one of their 10” subs as well.</p><p></p><p>Front three ways will consist of ES-5s in the lower dash area and an ES-03 / ES-1200is in a 3d printed enclosure up on the dash / a pillar area. I will be designing and printing that myself, as we just picked up a Bambu Lab X1C printer. I will also be building an enclosure for the QEX-1000sq. </p><p></p><p>Head unit is a Kenwood Excelon KDC-X705. Amp is an Audison SR 6.600 that’ll be run 2x280w at 4 ohm and 1x600w at 2 ohm. Just using the CDT 3-way crossovers for now. May decide to go full active at a later date.</p></blockquote><p></p>
[QUOTE="GoldCountryCA, post: 8885921, member: 690466"] It’s settled. I purchased my speakers from CDT again, because my ram sounds great. Took it a step further and also decided to try one of their 10” subs as well. Front three ways will consist of ES-5s in the lower dash area and an ES-03 / ES-1200is in a 3d printed enclosure up on the dash / a pillar area. I will be designing and printing that myself, as we just picked up a Bambu Lab X1C printer. I will also be building an enclosure for the QEX-1000sq. Head unit is a Kenwood Excelon KDC-X705. Amp is an Audison SR 6.600 that’ll be run 2x280w at 4 ohm and 1x600w at 2 ohm. Just using the CDT 3-way crossovers for now. May decide to go full active at a later date. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Builds
Car Audio Build Logs
2000 Jeep Wrangler
Top
Menu
What's new
Forum list
