Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
Car Audio Build Logs
2000 Camry Build
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="audiobaun" data-source="post: 8864070" data-attributes="member: 634282"><p>The last set of Massive components I ran the tweeters cooked and the Xovers melted approx.45 rms under rated. Ran some 6.5 mids and they did fine but sounded like azz, so those went in the rear doors on lower rms power.Tried to send in for a return for Warranty and and was told I ran too much power to them when I had pics of the Autotek Mean Machine 66HC sent as well as the entire amp set up. They still denied my warranty and lost my $ upon return. Shittty Customer service and Bull Shittt Non-valid Warranty. They never sent those back. Massive =s Trashive in my books. I ended up with a set of Cheap Polk DB 6.5 components until I purchased the MM series of Polk and both were far more superb than the two massive sets I had at the time. If you want some components that will take 150 rms on up.. you going have to look hard and spend some funds or build your own from raw drivers and look also look for some xovers that will take that power if wanting to run passive.</p></blockquote><p></p>
[QUOTE="audiobaun, post: 8864070, member: 634282"] The last set of Massive components I ran the tweeters cooked and the Xovers melted approx.45 rms under rated. Ran some 6.5 mids and they did fine but sounded like azz, so those went in the rear doors on lower rms power.Tried to send in for a return for Warranty and and was told I ran too much power to them when I had pics of the Autotek Mean Machine 66HC sent as well as the entire amp set up. They still denied my warranty and lost my $ upon return. Shittty Customer service and Bull Shittt Non-valid Warranty. They never sent those back. Massive =s Trashive in my books. I ended up with a set of Cheap Polk DB 6.5 components until I purchased the MM series of Polk and both were far more superb than the two massive sets I had at the time. If you want some components that will take 150 rms on up.. you going have to look hard and spend some funds or build your own from raw drivers and look also look for some xovers that will take that power if wanting to run passive. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Car Audio Build Logs
2000 Camry Build
Top
Menu
Home
Refresh