Reply to thread

Message

<blockquote data-quote="svarasnj" data-source="post: 5802922" data-attributes="member: 604580">So finally I got my comp amp and getting ready to install everything in my sig.Recently I changed my decision and got a comp amp, thats why there is only 4ga running from bat to the trunk, set of rca&#039;s and rm wire.Planning on running current 4ga pw to dist block and from there 2 x 4ga to the amps.Questions:1. Do I have to replace my 4ga with 1/0 run from bat to dist block . Is it absolutely necessary?2. Should I get fused dist block or regular is fine for pw?3. Ground wire. Should I also use dist block or running 2 wires is fine.4. If I decide to run 2 separate gw should I run them to separate spots or the same is fine?5. Remote wire. Do I run 2 wires or use a relay in this case?if you have any suggestions or want to criticize something please do so.thanks for your help</blockquote>

[QUOTE="svarasnj, post: 5802922, member: 604580"] So finally I got my comp amp and getting ready to install everything in my sig. Recently I changed my decision and got a comp amp, thats why there is only 4ga running from bat to the trunk, set of rca's and rm wire. Planning on running current 4ga pw to dist block and from there 2 x 4ga to the amps. Questions: 1. Do I have to replace my 4ga with 1/0 run from bat to dist block . Is it absolutely necessary? 2. Should I get fused dist block or regular is fine for pw? 3. Ground wire. Should I also use dist block or running 2 wires is fine. 4. If I decide to run 2 separate gw should I run them to separate spots or the same is fine? 5. Remote wire. Do I run 2 wires or use a relay in this case? if you have any suggestions or want to criticize something please do so. thanks for your help [/QUOTE]

Verification