Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
(2) 4 ohm 10 inch JL subs to 1500 watt mono amp @ 4 ohms
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="n2audio" data-source="post: 8319832" data-attributes="member: 540940"><p>It would help if we had model numbers.</p><p></p><p>I'm GUESSING you have the hfi1500d and you're looking at 10w1v3-4's.</p><p></p><p>If that's the case - yes, they'll work well with that amp.</p><p></p><p>You can wire the svc 4's parallel for 2 ohms. The amp is "rated" for 1000w at that impedance, but its actual output is quite a bit less than that -- probably in the 700w range.</p><p></p><p>Keep the bass boost off and set the gain a bit on the low side and it will be a good match.</p><p></p><p>The amp has two physical outputs, but it is still just one channel. A lot of mono amps are set up that way because it is common to need to run more than one speaker lead.</p><p></p><p>You can connect one of the 4 ohm subs to each output (a parallel connection) giving you 2 ohms at the amp.</p></blockquote><p></p>
[QUOTE="n2audio, post: 8319832, member: 540940"] It would help if we had model numbers. I'm GUESSING you have the hfi1500d and you're looking at 10w1v3-4's. If that's the case - yes, they'll work well with that amp. You can wire the svc 4's parallel for 2 ohms. The amp is "rated" for 1000w at that impedance, but its actual output is quite a bit less than that -- probably in the 700w range. Keep the bass boost off and set the gain a bit on the low side and it will be a good match. The amp has two physical outputs, but it is still just one channel. A lot of mono amps are set up that way because it is common to need to run more than one speaker lead. You can connect one of the 4 ohm subs to each output (a parallel connection) giving you 2 ohms at the amp. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
(2) 4 ohm 10 inch JL subs to 1500 watt mono amp @ 4 ohms
Top
Menu
Home
Refresh