gains

  1. C

    Lc7i rca outputs measuring mV w dmm

    I am trying to set gains on my lc7i but all i am getting is mV readings with 2 dmm...tried auto mode and selecting modes, what am i doing wrong?
  2. H

    Amp gains

    Tried setting gains with fluke meter like the videos show find your voltage, turn every thing off, flat and turn your gsun till you find desired volts and done. Well no and done. I either get OL or nothing and some times kw then blank or back to OL there is no find volts and done no and done...
  3. H

    Front stage gain voltage wont go past 10v, sub amp gains set fine.

    I am having an issue, I was able to set my subwoofer amp gains to the calculated 50v fine (nvx xad13) (sounds and works great), I go to set the gain on my sundown sdx 200.2 and gain maxed at the same volume I set my sub amp (same volume on the same headunit I had my last setup running on fine)...
  4. D

    Digital design M1D

    Hello all I just got a DD M1D amp and the gain is set really high like 3/4 of the way up. I had a Memphis VIV 1100 before this and it was only below half and sounded great. I have 2 DD 610’s D4 hooked up to 1 ohm. I’m getting 13 volts to the amp. I’m using a 4 gauge wire with a 100 fuse amp. Do...
  5. S

    Overkill

    Ay yo mayyn, My new amp has a 90A fuse and rates at 4 X 120 watts RMS. My Pioneer 6.5 front speakers rate at 50 watts RMS. The reason I got this amp was to bridge the rear channels to my subwoofer. But I'm concerned that even with the gains all the way down on the front channels, it might...
Top