Recent content by Zach Hutkin

I have two rockford fosgate p1 4 ohm subs and an mtx thunder 302 amp powering them. The amp is two channels and puts out 75x2 watts rms at 4 ohms or 300 watt rms bridged into 4 ohms. right now i am using one channel per sub, but the subs are 150 watt rms. would it be beneficial to try and...

I have an mtx 302 amp which puts out 75x2 watt rms at 4 ohms and 300 watts rms when bridged into 4 ohms. I am planning to bridge the amp and then run two 150 watt rms rockford fosgate subs (p110s4) off it. The subs are both 150 watt rms at 4 ohms. the subs are single voice coil so i'm...

I just bought a used Orion 8004 and it has a crossover built in. It has a built in crossover so that should be fine and I found out how to run both the front and back channels with one set of rca's. How much money will I need to spend on a distro block. The wire that I got with this amp is...

If I were to use one rca cable to send signal to my amp would I need a y-splitter and if so where would I need to install it? My headunit does offer subwoofer controls when I switch the rear channel to amp mode so this seems like the better choice. Would I loose anything but fader ability by...

I am looking at buying one of these four channel amps and they are all in the same price range. Which amp would you recommend I get. PS I know that none of these amps are great but I'm on a tight budget

I am looking at getting a 4-channel amp and the MB Quart NAU 460 in my car. This product is listed as a marine amp and I'm wondering if it will work properly in a car. I would just get the MB Quart ONX4.60 but it sells for $20 more. Thank for your help.

I am planning on buy to separate amps, a four channel and later on a mono/two channel bridged which I plan to put in my trunk. I really don't want to have to run the power, rca, and remote on cables twice. How would I have to go about wiring the amps to do this. Right now I am thinking that I...