Recent content by YellerF150

  1. YellerF150

    Need a little help. Please!

    So let me ask you something else, I'm getting ready to upgrade my door speaker, should I do components in all four or components in front and coaxil in rear? and I want to run them off an amp via the high inputs on the amp and run it from the apeaker outputs on the HU to the amp then to the...
  2. YellerF150

    Need a little help. Please!

    I hadn't either, hence why I came here for advice, I'm a novice at this, I know a little about wiring systems in and adjusting gain and all, but this had me sumpted. When I took the amp out I hadn't had any problems with it before. I just went ahead and replaced the subs and amp to be done with...
  3. YellerF150

    Need a little help. Please!

    Yea that's quite possible but he said it was fairly new and he hadn't used it much, but who knows....
  4. YellerF150

    Need a little help. Please!

    Yea That's why I'm finding it wierd and came here to see if anyone had any advice or had the same problem before. We double checked the wiring to make sure it was right and it was my new amp and subs are wired the same way with the same wiring and have no problems.
  5. YellerF150

    Need a little help. Please!

    I didn't check them with a dmm he said he had, the sub was the JBL GTO1214.
  6. YellerF150

    Need a little help. Please!

    His sub was rated higher than any i had and I never had any problems when I was pushing a pioneer TS-W254R 10(rated 250rms) with this amp at 1/2 gain.
  7. YellerF150

    Need a little help. Please!

    Yea we were thinking the gain was to high but we had it all the way down when he hooked his sub to it then turned it 1/4 up and then at 1/2 way up it blew the coil on his sub. And when I had the system installed in my explorer I never had a problem with it at 1/2 gain.
  8. YellerF150

    Need a little help. Please!

    Thanks for the reply mylows. I decied to replace the amp and subs. Because the amp blew a buddy's sub that was rated over 750rms when he said"hey lets look this subs to it and see what happens........., hooked new amp up with the same wiring in the same locations and all is fine so it wasn't a...
  9. YellerF150

    Need a little help. Please!

    So I decided to put the system I had on a shelf in the garage in my truck finaly. Rockford Fosgate Punch 500.2(500watt/2-channel) amp and 2 Rockford Punch 8" subs Amp was last used about 2 years ago and worked flawlessly when removed. Subs were last used about 3 years and one was blown. So got...
Top