Recent content by yanksfan407

  1. Y

    Amp Tuning??

    ok thanks now my stereo deck says pre amp voltage is 2 volts, what do i set the gain to? I have a choice of MIN-, -, -, NOM-, 0.5V-, -, MAX-   ---------- Post added at 12:43 PM ---------- Previous post was at 12:43 PM ----------   And the bass equalizer is from 0-12 dB, I choose 0?  ...
  2. Y

    Amp Tuning??

    Or bass equalizer on the amp? What do I set this to?
  3. Y

    Amp Tuning??

    Bass boost on the stereo deck? Just confimring
  4. Y

    Amp Tuning??

    I need to know what to tune my amp to. I have an Alpine MRP 500 at 2ohms by 500 Watts RMS powering an Alpine Type R Dual 4 Ohm Voice Coil. I have two amps powering two subs. One amp per sub. Someone help please. I dont know what to tune my knobs to on the amp. Do I install them and adjust it as...
  5. Y

    need help with grounds or something in my electrical system

    You can check a couple things. First most obvious and simple is check all connections and make sure they are tight and solid. Next would be to check all your grounds and make sure they are good and strong and in a good place. Check inputs into amp and into back of stereo as well.
  6. Y

    Best place to ground in an Explorer?

    +1^^ Seat bolt is a very good ground and I have used it before with no problem.
  7. Y

    Two Alpine Type R Subs with questionable amps??

    I have two alpine type R subs, SWR 1243. I have an Alpine MRP 500 amp. Now my choices are either two MRP 500's or one MRP 1000. Now my question. What would I get better performance out of? The two MRP 500's or the one MRP 1000? Any help would be greatly appreciated.
See more
Top
Menu
Home
Refresh