Recent content by xshellshock

I know you can set up to bridge the 4 channels into 2 channels through the amp, but can I bridge these two channels together to make it 300x1? Thanks in advance.

pmed

bump. no ideas?

if you're using 4gauge + you need to use at least 4gauge -. Go to an electronics store, you could prob get pretty close to a spool of wire for what you're going to pay for a coupler and extra wire elsewhere. I think I paid 40 bucks for 25 ft of good quality wire.

I just purchased 2 stealthboxes for my 2002 ram 2500. The one in the front contains a jl 12w3 and the rear contains two jl 10w1 subs. Both boxes are wired at 4 ohms. I'd like to run both boxes off of one amp if possible. As of right now I have 2 jl 300/4 amps which were used by the previous...

lmao at that sig

pmed