Recent content by Wolkt

Thanks again for your input. However, with regards to the second part of your answer: The JBL Fuse unit is 2ohm when using combined or wired as 2 separate units in parallel, or 4ohm each when separated. See attached specs: So only options to wire to JBL Club a754 amplifier is: Connection...

Thanks for your response. So yeah I think that my second option idea would be best in this setup. Wiring 2 separate Fuse units (100watt RMS @ 4ohm) left & right - wired on the a754 amplifier as left and right subs on channels 3 & 4 (75watt RMS @ 4ohm). The a754 has LPF and HPF settings on...

I think you misunderstood the Fuse part. The Subs I'm using is the JBL Fuse Sub. This Fuse Sub is 200watt RMS 2ohm when used in 'fused' (compined unit state. But when 'split' (separated) each unit has a 4 ohm load. See product links below: Hence my question about wiring options: Connection...

Thanks for the feedback guys. However I'm more specifically interested in which of these options would be best to connect the JBL Fuse Sub woofers (separated as two units at 4ohm each) on the JBL Club a754 amplifier: Connection Options: 1) 2 separate Fuse units (left & right) on channel 3 & 4 -...

Would really appreciate advise on the following setup scenario: Would the following setup work well on the JBL a754 amplifier (a754 specs - 75 watts RMS x 4 at 4 ohms (100 watts RMS x 4 at 2 ohms), 200 watts RMS x 2 at 4 ohms in bridged mode (4-ohm stable in bridged mode): Speakers: JBL Club...