Recent content by very lost

Memphis ST500D I know the size of the amp is: 6.5" x 10.4" Does that include the mounting feet? I am tring to figure out the approx distance from mounting hole to mounting hole. I dont have my amp yet and need to make a metal mounting plate so I can mount it up under the rear dash. Thanks

I have (1) 10w6V2 sub and a Memphis 16-ST500D mono amp and I am using the stock Honda H/U. The enclosure is a small (non ported) fiberglass one. What should I set these settings settings to?

I have (1) 10w6v2 (dual voice coil) and a KENWOOD EXCELON 401m mono amp. The sub has (1) main positive, (1) main negative and 4 jumpers ( 2+ & 2- ). Wiring it parallel (2ohm) : I jumper the 2 negative together and jumper the 2 positive together? Am I understanding this right...

Ok i understand now. thanks

What size should I make the port?

Alright, you have convinced me to remake it with 3/4" MDF. I think I will glue the top on this box and see if I can blow it up.

How about this: With all of the red braces in the center of the box.

I made a jig and used a router. I though since it was a small box I wouldn't need to. Where should I brace it?

This is my first "real" box I have built other than the Frankenstein ones when I was younger. I am using the plans that JL recommends. 22"L X 12"H X 10 3/4"W with a 1 1/4" port. I know I wasn’t supposed to use particle board but I had it left over from something else. I wanted to save on...

I decided to use a "line out converter" instead of the clean sweep. I will look it to those amps you mentioned.