Recent content by towncarblue

i have an Image Dynamics CXS {6.5" component set} . one of the woofers broke so i bought two Rockford Fosgate pps4-6 midrange drivers to replace them {while still using the ID crossover and tweeters}. 2.5 years ago i replaced the car but didn't transfer over the speakers. kept them in storage...

i bought the Pioneer GM-D8604 . not bad at all. adjusted gain using a DMM . i think this is louder. i can hear the voices/singing more clearly. had to adjust my old eq band settings a bit on the highs.  i would recommend this amp to  friends

whats the snr of the Pioneer GM-D8604 ???? im seeing two diffrent ones......

how about the nvx-jad-800.4 , there are decent reviews for it online https://www.amazon.com/gp/product/B00852W0HQ/ref=ox_sc_act_title_2?smid=A2V3063JU9685N&psc=1

left... 2ohm (4ohm + 4ohm) right..... 2ohm(4ohm + 4ohm) on a two channel amp i have a separate amp for my subwoofer { works fine }

i disconnected all speakers and turned on the radio, the amp still goes into protect mode . each speaker is 4 ohms, 

i had a 2-channel amp , ppi phantom P600.2 connected to four 100w rms component speakers. its going into protect mode as soon as it turns on. { I've had this amp for years } i need a replacement. unfortunately, the prices for this amp skyrocketed. i paid around $100  for this amp , now its...

i want a ported box of 1.5 cuft @ 35hz as recommended for a stereo integrity si mag v3. complete box outside demmensions -- 28"L x 15"H x 10"D length and height cannot be adjusted. im not trying to go deeper than 10" but i can if its a must

i decided to buy a stereo integrity mag v3. they got good reviews , good price {$200} and they work both sealed and ported . with the extra money i was planning on building a ported box of 1.5 cuft @ 35hz as recommended. i used re sub box calculator to find my box specs. complete box-- 28"L x...

i need to find myself a 12" sub that can be put into a sealed enclosure of ONE Cuft and can handle around 600-1,000 W rms { kicker zx1500.1 is my amp } i want some deep bass and vibration { dont care if it gets loud }. i usually tune the amp's LPF around 80-100HZ {dont have a sine wave...

ok. its just not worth it to get new speakers

is that 1.5db per speaker...??? that would mean an output of plus 6db

i have a audio system in my car right now. image dynamics cx64(92db) front and polk audio db6501(93db) rear, at 100w rms each speaker { 4x 100w rms }. i see alot of 2 channel amps coming with 150-200 rms per channel. what would be the benefit of getting some 150w rms or even 200w rms door...

sealed box specs in cu.ft what is a better /accurate sub box calculator....????

i only DO custom boxes. i use re audio box calculator to make the boxes up to spec. 3/4 mdf from home depot all the time i had a re sx 12 { not too sure bout the name... its the 1,000 rms one } in a ported L-box built to their specs. did not like it , switched over to 2 re se12 in sealed box ...