Recent content by tortuga1

the manual says the amp can do 220 watts per channel at 2ohms

Update 2: I received a replacement ppi amp yesterday (thank god for the $10 warranty I bought). and I will be receiving my new hu today (thank god again for the $10 warranty I bought). what I noticed was that one of the channels on my 2ch amp is not working , old amp with no warranty(tested it...

4Runner

I’m looking into the alpine cde 152 with 3 sets of pre outs and 9 band eq and the alpine cde 143bt with 2 set of pre outs, and 3 band eq. Which one would you choose from these to? I’m not sure if Bluetooth is necessary isn’t usb for iPod better in regards to sound quality....or is the Jvc you...

Just the stereo.

This was a budget build I had a alpine Cde-151 . Any suggestion for a stereo under $120. I have only used alpine so I’m not sure what else is ok

Update I disconnected the sub amp and still the components amp didn’t turn on. I double checked and I’m not getting power. On the battery side of the fuse I’m getting 12.4 v. on the other end of the the fuse I get 1.4v but the fuse looks fine is it the fuse or the fuse holder. Another thing I...

When I disconnect the ppi amp power and ground. the components amp should work and if it does not than the stereo is bad?

I was going to adjust my gains for my amplifier. ppi ice2600.1 so i disconnected the speaker wires that goes to the sub but i left it connected at the amp. It started to smell like smoke I didn't figure out where it was coming from. The amp turned off and wont turn on. I then discovered that...