Recent content by tomz

We have a Blade 4.2 2 channel 2X200W @ 2 ohm amp. We would like to "bridge" both channels to obtain a mono output of 1X400w I already know I can successfully split the input signal with rca's & y it to each channel I'm concerned if I just splice the out + to + & - to - I will blow the...

Thanks for the reply. The 8w6 JL Audio uses a dual 6ohm load. We hooked them up in parralell which gave us a 3 ohm load... Correct? We then hooked up another 8w6 in parrallel with the first speaker.. + to + & - to -. I'm assuming that reduced our load to 1.5 ohms, since we have two...

We are trying to hook up a used amp. Blade Audio... This is a 2X200 watt 2-4ohm setup.. This amp has two distinct amps, 1 for each channel. We setting two JL 8w6 with the voice coil & sub in parrallel(load of 3ohms). Hooked up one speaker to each channel. The amp didn't want to seem to...