Recent content by tim45255

the amp is 1500 watts its a good brand amp and i have everything turned on low also thanks t2 i will check the ground cable

hello, I have a 1500 watt power acoustic and every time i turn it on it will go into protected mode if i take off the speaker wires from the output then take the fuses out and put them back in and turn it on it will not go into protected mode also it has a lot of engine noise in it i don't know...

thank you for the advice and help

sorry repost

the total rms of my bazooka ba 1500 is 500 rms and the second amp is a roadstar amp and it has a 200 watt rms

Alright I know its not the best idea for best performance but both my subs are only 3 months old i got the 4 ohm from a trade and its a coustic. The wireing kit is rated for 1200 watts and I added it up and it comes out to 1150 watts but i will not have them turned all the way up

I have read the whole post What i will do is connect a second amp fr the 4 ohm i have a 500 watt amp that would run it i have a output on my other amp for rca's also would i have to run another power wire from the battery or just get another power cable and hook it to the end of the power cable...

I have a brand new 6 gauge wire kit and a 12 v battery also a 110 amp alt

Hello, So I was told that this amp was a 1500 watt but its 750 watts max. Its also a mono block but it also get really hot and I have 2 12's on it. One of the subs is 4 ohm and the other sub is 2 ohm. when i turn up the volume and the bass gets real deep the amp will go into protected mode and...