Recent content by thetntstick

1 ohm on a twisted sounds amp at 1400 watts. After displacement the box should be a little under 4 cubic feet. I have two 4 inch aeroports at 14.6 inches of length each. According to the precision port length calc thats a 32 hz box tuning. Will this work good? Or should i say **** it go buy an...

hey guys this may sound like a stupid question but im finally installing my dd m4 and two batteries next weekend and am confused about something. i have a power wire running to both batteries in the back of my truck so yes the main battery is isolated from the system. when wiring the amp should...

couldnt i get dual 1 ohms speakers and wire one parallel and one series to get 1 ohm load and parallel them both to get .5? I could just rewire to 1 ohm if it isnt going too hot. or rather too hot

ughh idk im not to sure it will run fine at .5 ohms...such nice equipment down the drain if i fk up.

as long as it stays above 12 right? plus If I build a big box for my specific speakers, wont the impedance rise a good bit?

you're right...my bad.

I know but I was implying my stock battery will also be charged from the alt.

I just want something that can be pushed hard and sound good doing it man. I want something that is responsive and can handle my M3 at .5 ohm-1ohm. Im thinking these 3500s can do the trick. Im not expecting them to be as loud but i am expecting them to sound a hell of alot better,

Oh! btw this alt is replacing my oem...so it isnt an addition

Nissan titan crew cab. going on the passenger side of vehicle. Ive owned a 3500 before and it was the best sounding speaker ive had. Im sticking with DD because they have never succeeded to fail me. I have a 9515 right now and it sounds decent and very loud but im thinking this will sound better...

you think I could wire lower lol

hey guys got a nissan titan here and want to upgrade door speakers. I have here attached a picture showing what and where the speakers are. I know this isnt the section for amps but im looking to pay 400 for amp and speakers.

Well... for me sound quality> loudness... I want to be loud but sound good. Hmm... i might get 10s instead and build a bigger box. Lets say 3.50 cubes net? tuned at about 35?? thats dd specs

Got an M3C. Should I get two 9510s or 3510s? Either way the subs will be tuned to DD specs.

Hey guys I have a M3C and will be ordering some stuff for my electrical monday. Im getting a singer 250a and two xspower 3100s. Speakers will be wired to an ohm. Is this enough? If it is could I possibly wire at a lower load?