Recent content by thedon18

Can u guys let me know which components u suggest. I currently have Infinity kappas, 5 1.2, but they have no midbass, im looking for midbass. Let me know what u suggest. I have a 600watt rms 4 channel.

ok, then you should NOE, not to capitalize all these letters : Obsession Never Ends.

"I noe I noe, i should do it myself, but I dont care to deal with that, so id rather let someone else do it" I dont noe how to very well, nor do i care to learn, id rather pay someone to do it. so, all i needed was for u guys to pick one of the two

im wondering what u guys think would be cheaper: buying wiring to hookup a sub to amp ( 0Gauge) with fuses and distro block, and shit like that. and, having a shop hook it up. Or buying the stuff from the shop and having them hook it up? I noe I noe, i should do it myself, but I dont care to...

ok, How bout if i wanted to wire my MTX 15", at 1 ohm? its a dual 4ohm, the diagram only shows how to wire to 2 ohms, how do i wire it so that the amp sees 1 ohm???

can u tell me how i would wire 2 10" kicker cvrs they are dual 2ohm, and im wiring them to a Hifonics two channel, it isnt 1 ohm stable.

I just want to know, if i have an amp that accepts 2 gauge power wire, and i run 8 gauge for about two weeks until i can afford the whole 0 gauge to 2 gauge setup will it stress out/damage my amp???

How can i figure out my amperage output, thus what size circuit breaker i need. I have 2000rms hifonics mono, and a 4 channel audiobahn 600 rms.

I have a Hifonics Brutus 2000 rms, and an Audiobahn 4 channel 600 rms amp. how do i noe how much amperage they put out? how big should the circuit breaker be? 150 amp? Please let me know

my amp is a 1600 rms at 1 ohm hifonics brutus. Its gonna be wired to a MTX T9515, currently i have 4 gauge to a block, then 8 to each amp (Speaker and Sub), i wanna give the sub bigger wire, so Can i just keep my 4 gauge and run that directly to the sub amp, or should i run 0 gauge and then...

I Want To Run 0 Gauge To My Sub Amp, I Currently Have 4 Gauge Running To A Splitter, And Then To Both My Sub Amp And My Speaker Amp. What I Am Wondering Is Wheter I Should Run A Sinlge 0 Gauge And Then Split It To Each Amp, Or Two Seperate Wires, A 4 Gauge And A O Gauge, Seperate Wiring For...

their screwed into the rear deck, where the factory speakers used to be

im looking for midbass, i currently have infinity kappa in front and back, but the rear 6 1/2's arent puttin out shit for midbass. Ive read about these midwoofers, do they replace the rear speakers??? and are they the best solution for midbass?

I really hate my current speakers: Infinity Kappa''s, they really lack midbass, they are loud and crisp, but lack midbass. So I wanna replace them with either the JL Audio XR525-CSi or the MB Quart QSD 213, which set would give me the best midbass, while still being durable? They would be...

what size wire should i use for mtx thunder 9500 15" off a 81001 mono? over 1000 rms, 0 gauge or 4 gauge?