Recent content by Sundownaudio01

I used a Windows program for the box calculations. I could have used multiple smaller ports but they would’ve had to be much longer. It calculated for the 34hz tune 22 square inches of port space if I remember right. 5” port was right on the spot just can’t find any port kits long enough and...

The SA-10 and the EVL in my opinion sound no different. At least to the ear they aren’t. I currently have the Skar in the same box so it’s constricted a little on box volume but I don’t hear any audible SQ difference. Would have definitely kept the sundown just didn’t know the real problem and...

I know I wasn't. Have skar in the sundown box at the moment and it still sounds great to me. The sundown wasn't blown i just had a borked ground connection on my line output connection and ordered the new sub before I knew that was the problem

Long story short I thought the sundown was blown when it was actually a bad connection from the line converter and the Skar was rated for 1000 watts vs 600 for the sundown and didn't want to risk blowing another sub

I know there is probably 1000 threads about this on here but I haven't been able to find a clear answer to what I need. I've recently bought a Skar Audio EVL-10 to replace my Sundown SA10 and need to build a new box. The question I have is for the box tuning. Skar recommends 40Hz. My last box...

Okay I am probably going to do the dual 10’s. What if I were to up wattage to 1500 rms. My current alternator is 145 amps. Would the votage drop hurt sound enough to make a bigger system sound worse than the smaller setup?

I’m having to change my system up because one of my subs died. For an SPL setup should I go with a pair of Sundown SA-10s or one sundown x12? Either way I’ll be powering at 1100 watts rms since I don’t want to put too much excessive power on my alternator and both setups will be rated at 1500...

I’m thinking that’s what happened. From being overpowered and having it for few years I think the coil finally got too hot and there’s a bubble in it now. Going to just recone it and hope that fixes the problem 

Took it’s ps4 away but it’s still throwing a fit. Seriously though just got out of box. Was a little dusty in the box but not bad. Pushed cone down and there was no rubbing. Tensel leads, spider, terminals and coil from what I can see are all good. Not really sure why it’s doing this. Don’t...

Checked ohm load this morning. Haven’t pulled amp just checked the leads coming from sub and it measured right out at 1ohm. 

Also will add that it plays fine for first 5 to 10 minutes of listening before this happens and only does it at high volume. Once at medium to low volume it plays with no distortion 

Okay so I’ve had this Sundown Audio SA-10 v2 in my car for about 1-2 years. It’s been running at 1000 watts rms which is 250 over spec however everything I read up on said these subs could take way more than that. Anyways here in the past few days the sub had been cutting out making very little...