Recent content by StreetRacerMX5

Okay,I'll keep this as simple as possible.I want to install an active crossover in my system but have a few quick questions.First one being, Should I even install a crossover? I have a Kenwood KAC-9105D amp and an older MTX RT-X01A crossover.I like the look and want to incorporate it into my...

How about this amp? MTX Europe - RT404 or should I find one rated for 75w rms @ 4ohms?

I'm assuming I'll need a 4-channel amp?

Part Number: RTX4BT Description: 4" Bullet Tweeter RMS Power (Watts): 200 Peak Power (Watts): 400 Impedance: 8Ω Sensitivity (2.83V/1m): 97.0 dB Frequency Response: 2.7kHz - 22.3kHz Mounting Depth: 2.1" (5.33 cm) -------------------------------------- TERMINATOR 6X9 TRIAXIAL...

Yea the other Speakers are MTX 4" Bullet Tweeters (Rear) and MTX 6x9's (Rear) Both powered of off the same amplifier

Optima Yellowtops and a capacitor if you aren't running one already..Alternator upgrade is never a bad idea and like the above poster said make sure your power and grounds are of sufficient size.

I haven't purchased a H.U yet but it'll probably be a newer Kenwood deck with two outputs..I posted a link with the speaker specs and like I said I won't be powering them from an amp just the H.U but I don't feel a need for passive x-overs as I find it to be overkill when I can just wire in some...

Kenwood KFC-835C Kenwood - KFC-835C

I'll post the part number later

How many hz should I get 300hz or the 2800hz?? These aren't tweeters but 3.5" Kenwood speakers that will be powered by my H.U