Recent content by StillLearning

Hey all, just wanted to update on my situation because I think what I dealt with was something somewhat unique. I do believe I fixed my issue for the most part, I think it was the box I was using. The box I used is a bandpass box I got in 2010 and messed around with a Lot! This means I did...

Thanks for the info, so basically anything that can muck up OHMs Law, do you have any ideas of diagnosing this? Off of above it sounds like a starting point is attempting to measure voltage and resistance while the sub is playing, I know my power source stays between 13.7 and 14.5 VDC so if...

So my dual coil Subwoofers are rated at 50-400 (200 W per coil) Watts RMS each and since there are (2) that would make the higher RMS draw to be 800 Watts. The amp I am using is rated for 950 Watts continuous power output at 2 Ohms, clipping occurs from what I have seen when there is not enough...

So that would mean there is no sound difference between using two terminals and 4 wires rather than all four terminals? I guess that's pretty much the definition of single channel, right? I was thinking more terminals would have better power distribution, but if they're all on the same node then...

BCortell, I guess that is a good point to bring up with it being a monoblock and all. so maybe its not 2 channels and I just dont completely understand my wiring scheme. Correct me if I am wrong here but if I have a dual voice coil at 4 oh,s and i wire it in parallel, that would cut the ohms in...

Hi all! This is my first thread and I am excited to get involved on this forum site. I am posting here because I just upgraded my car subwoofer system's amplifier from a Sony XPLODE 1200W to a Audiopipe 1500W, I still have my old Kicker CompVR 07CVR124 subs wired to 2 ohms and on their own...