Recent content by stainless1911

I dont know what Head Unit is there. It's an off brand thing that I got a couple years ago from the front counter at the auto parts store. I paid 27$ for it on clearance.

So I set the output voltage to 2 on the 3200, and connect the two with a pair of RCA? Not sure what you meant about the Htz. ???

I want to go from the radio stereo RCA out to the input on the top amp for the first 2 subs , then go from the first amp to the second amp to run the single sub. Which wire do I need to connect the 2 amps?

I'm stuck with what I have.

That really wasn't very helpful.

It's waht I had. I wanted the P-2s to pick up the lower frequencies better, and the Kenwood to pick up the higher bass frequencies. I did the same thing in my camaro. Theres an HE-2 DVC bridged to 2 ohms, and 2 SVC Sony Explodes at 4 ohms. I use the LPF on the HE-2, and run the Sonys EQ on full.

The car in question is a Fiero. I have the 2 12" P-2s in the rear trunk, and the single voice coil Kenwood 12" in the front trunk. The build thread is here. Lots of pics. http://www.fiero.nl/forum/Forum2/HTML/124986.html

1st post. I have an issue. but for simplicity I will start with the equipment so you know what we are working with. 2 Rockford Fosgate P2 subs. 12" dual voice coil wired for 2 ohm Powered by Autotek M3200.2 2 channel amp. 1 Kenwood Excellon single voice coil 12" Powered by Autotek M1600.2...