Recent content by sportyaccordy

  1. S

    Best components/midbasses for system with no sub?

    There is an MTX Thunderform enclosure for my car, but naturally it's sealed and only has 1.3 CF of volume. F3 will be high AF. Again I know it's a tall ask but if I went with a loaded enclosure I would want something small with low extension good for 300-400W RMS. Again, a tall ask. Any other...
  2. S

    Best components/midbasses for system with no sub?

    I have an 09 Civic sedan without the rear deck sub. I want to upgrade the stereo, but I don't want to do a sub. I need my trunk and to do it how I want (single 10-12" tuned to 30Hz) will take up too much space and add too much weight. What component systems will net me the most bass? I will...
  3. S

    Where to get cheap passive crossovers?

    I have Dayton DC mids and Pioneer tweets... no, its' not pretty but it gets the job done... I'd like to get some 2.5KHz 12 dB xovers, but I don't really want to spend $40 on the set from PE on a set of $40 mids + tweeters. However, I am getting some overlap I want to get rid of. I pieced...
  4. S

    SOLD new in old MUST GO

    Amp came, worked, dude even told me when they tried to deliver the first time.... rest assured the experience will be good buying from this dude
  5. S

    Crunch PZI-1500.1- is it really 1 ohm stable?

    Does efficiency change with the load impedance?
  6. S

    Crunch PZI-1500.1- is it really 1 ohm stable?

    So 1728W will pop the fuses (at 14.4V) Cool I really doubt I will be bumping it that hard for that long anyway. I just want the power ceiling
  7. S

    Crunch PZI-1500.1- is it really 1 ohm stable?

    What can it do RMS wise at 1 ohm?
  8. S

    SOLD new in old MUST GO

    Check ur PMs please.
  9. S

    Crunch PZI-1500.1- is it really 1 ohm stable?

    I have a Rockford Fosgate TI 15 and I'm looking to pick up this Crunch amp just to bump maybe 500W RMS max. It's a dual 2. Could I get 500W out of it in a 4 ohm config, and if not would it be safe to run in a 1 ohm config? Also is the TI a good SQ sub? It gets down very low but it seems a...
  10. S

    WTB: 500W RMS @ 4 ohms mono or 2ch bridged amp near NYC, <$100

    Bump, I know someone has an amp out there. I got an old Profile CL600M for $50 bucks but it got stolen!
  11. S

    WTB: 500W RMS @ 4 ohms mono or 2ch bridged amp near NYC, <$100

    Would also do a 4ch amp with 250W/channel at 2 ohms. Looking to power a RF Power TI 15; one of the channels on my Cadence TXA-3004 went bad and I want to upgrade while I send it out for repairs. Looking to pick it up this weekend, would def. prefer pick up. LMK what you have.
  12. S

    Budget 15s?

    I don't have the trunk space nor do I want 2 subs....
  13. S

    Budget 15s?

    I am looking for a 15 to put in a sealed 2.0cf box that I can throw about 300-400W at. Priorities are for the sub to have good Q for punk/jazz while having decent low low end + rolloff + no droniness for rap. I really like the MB Quart RWE-352; haven't really found anything else in that price...
  14. S

    Tweeter is way too loud... are there active speaker side x-over/eqs???

    There's nothing filtering the woofer... Maybe a full passive 12db xover is the answer
  15. S

    Tweeter is way too loud... are there active speaker side x-over/eqs???

    Obviously "they" make passive speaker side crossovers I want to know if there are active adjustable speaker side ones out there.
Top