Recent content by slwilson6

black, egg shaped (when the end caps are on), 12 inches wide by 15 inches long (again with the end caps are on)...

i just wanna know if i am gonna challenge my new subs with this amp or should I finally retire my nearly 12 year old amp and get a new one. money is tight and this amp has never let me down yet.

do you think around 400 watts in my application as well?

i have always heard that they are really underrated on their wattage output. i just would like to know if it is going to be enough to push around 500-600 watts on 2 subs versus the one DVC.

bump......i looked at punch 2's today. mounting depth of 5.75" and .59 cu ft of airspace. any other suggestions?

you think so? I've had this amp since 97 and I don't think it has ever been wired at anything higher than 2 ohms mono. it might have been closer to 3 when I ran 3 single voice coil 10's off of it. i know it runs warm sometimes when I really push it hard but it is still working fine. not sure...

bump............

hifonics 1208d-900W @ 2 ohms and gain it down a bit and easy to expand on. good price for the power.

I am redoing my system in my new truck (Nissan Titan Crew Cab). I can squeeze a pair of 10's under the back seat with very little airspace (approx .57 cu ft per speaker). I have been considering the JL Audio 10W3's cause they have small airspace requirements and mounting depth. I have also...

RF 200.2 bridged 2 ohm mono pushing rf 10" he2 DVC-been using this amp since 1997 the sub since 2003. had 2 punch series 1's 12" before the DVC. RF 360.4 pushing 2 sets of Kicker component 6.5"-been using this amp since 1998 the components since 2004. before the components the amp was pushing...

i have and have been using an old punch 200.2 bridged to 2 ohm mono from 8.1 volts. does anyone know about how many watts this might be considering this is one of those underrated amps from the 90s. someone told me at one time that it might be pushing 500 watts at 2 ohms. does that sound...