Recent content by skiingsean

I'm replacing an older MB dsc2150 amp with a new Infinity Kappa One and wanted to get some thoughts on wiring. The Kappa one says it's stable at 1ohm yet boasts 500rmsx1@4 or 800x1@2 -- I'm wiring up two infinity 1262W's which are both DVC 4ohm. Is there any reason not to wire these down to...

I have a meter and can take the panels off but it literally doesn't make statistical sense that 4 Xovers went bad at one time. I'll hook a 9v up to them in a bit and write back but I'm sure they will push/pull -- I also need to crank the vol and listen closely as so far i haven't heard any...

speakers (tweets + mids) --> Infinity Reference 6030cs 6-3/4" component speaker system — also fit in 6-1/2" openings at Crutchfield.com

yes from the kappa 4.

Hrm sry thought when I signed up and put in my setup into my registration it'd show on my sig. Setup is a Pioneer DEH-P7200HD, 2x infinity 6030cs's, 2x infinity 1262w's, a kappa 4, and a crappy mb quartz --- No clue what happened but all 4 door mids just kapoot as if all 4 crossovers went ****...

Also it doesn't sound like I'm getting any line noise to the mids.. so I'm hoping it's not the Kappa 4 .. but I guess I'm just waiting for someone to say it is :s

Last night after getting a phone call and turning down the volume to about 1 or 2 I found out that my mids completely quit working. This makes no sense as my tweets work fine and my subs are receiving low line signal. After turning the volume back up all 4 mids literally just quit working...