Recent content by Simon96Taco

I haven't made the box yet.....Im' leaning towards sealed though, for the sake of simplicity.....this will be my first box building experience.

cool, thanks. So, in your opinion, will that be adequate to power the 10 in a small sealed box?

no Problem, thanks very much for your help! 160w RMS for the sub Im' running is not too bad. It's only a low end Pioneer IMPP TS-W254C - spec sheet says it's good for 250w RMS, so 160 is not bad. Could you link me to the site where you found info for the MRV-F300? Thanks again bro

Well that *****. How do you know for sure? All I want to run off this thing is the sub. I think if I can only bridge to two channels, I'll only be getting about 60w RMS into the sub. If I bridge down into 2 channels, can I twist the + and - wires together on each side and then hook them up...

Alpine V12 MRV-F300 It says on it - Alpine 4/3/2 channel power amplifer MRV F300 My roommate says that I can bridge it down to one channelby connecting ch4 (-) to ch1 (+). Does anyone know for sure if this is possible? The guy that I bought it from only bridged 2 of the four channels to run...

Last question - when deciding to go ahead an build the box, should I go with the recommended sizes that WinISD gives me, or should I go with the manufacturer's (Pioneer) recommendations? They are quite different. For example: The Pioneer spec page for this sub recommends 0.9ft^3 with a 3x13...

Hmm....ok ....that's what I sort of thought at first. Is that the case with any/all subwoofers? Or does it depend on the driver? Last question - when deciding to go ahead an build the box, should I go with the recommended sizes that WinISD gives me, or should I go with the manufacturer's...

Yes, at first I had planned on a sealed enclosure, but then someone on another forum mentioned that the ported box would be more efficient and would require less power to run it cleanly. I just wish there was a simple yes or no answer Right now I'm living in Lethbridge, AB, about 2 hours...

Here goes - I'm sitting on a new Pioneer 10" IMPP W254C (low end, but decent from what I've heard) and an Alpine MRV-F300 V12 amp to power it. The specs for the sub that I have been using in WinISD are here http://www.pioneerelectronics.com/Pioneer/Files/ts-w254c_spec_20011241029364900.pdf I...