Recent content by Silverbullet555

I'm assuming you are talking about in wall SPEAKER wiring. It's still speaker wire, it's just got the extra cover on it. I doubt it does anything for shielding, but I would think it would do fine. I used the stuff from parts express that is for direct buriel and in wall in our last boat and it...

My tower speakers just got a little more complicated. I have a pair of Kicker KMT6 speakers on my tower and 2 pair of Polk DB651 speakers. The Kickers are in a single enclosure, wired at 4ohms with a RMS of 150 watts. The Polks are able to be wired independently, in series or in parallel as...

Since I am going to go through the hassle of replacing the stereo in the boat, I might as well put the subs in while I am at it. I am not looking to cut into the boat, but rather put two boxes into the storage areas On either side of the boat. I could use the Kicker SKM10 enclosures which would...

I've been doing a lot of reading and it seems that good information is hard to find. Maybe I am looking in the wrong spot. I considered using 3 Eclipse EA4200 amps or an MB Quart Nautic 660 or 2 alpine pdx's or it seems like a million other choices. I think I am narrowed down. Choice 1: I...

I don't think I communicated really well what they are. They are an older pic of these. I can chose how to wire them as the terminals are on the outside so I can set it up any way I want.

I think I am really overthinking this and I just need to order the amps and get going. The one question I really need to answer now is can I run 2 channels at 2ohm and 2 channels at 4 ohms on the same amp? My tower speakers consist of 2 double pods. The wiring is done in the tower with only 2...

Just looked it up and realize PG is phoenix gold.

Space really isn't an issue. Our cobalt has a great spot behind the console in an area that does not get wet. There is a vertical wall that is probably 18" wide by 24" tall where the wires run to and the stereo is housed. It doesn't get much air flow in there, but there is a lot of room in there...

I'm sure this has been asked before, but I didn't see my situation when searching. Our boat has 10 Polk DB-651 speakers. 60W @ 4 ohm RMS. 6 of those are in the cabin and 4 are on the tower. The tower speakers are wired in parallel and the cabin speakers can be wired individual or parallel. I...