Recent content by SHMaRiM

Good post and thank you for the reply. I currently have a 10" JBL sub and at the time, for the price, it was a steal. It's not anything from their higher end section, but works for my application. I was always skeptical of JBL because of other things I had heard in the past. I don't really know...

Bump... Anyone with info on MB Quart? From what I've heard their old stuff is excellent, but there is very little information on their newer product lineup.

If I get new door cards like I was already planning on doing, they come without holes for speakers. I can easily cut a 5.25" hole in the rear instead of a 4x6. There is about a 5.1" tall open section in the back panel that I would need to trim in order to fit some 5.25". Given the amount of room...

I'm looking at my rear speaker location and I think I can fit a 5.25" in the rear as well with a little modification. So... I have a few questions. 1. Would it be better to put a coaxial in the rear and component in the front? Or use components on both and drill a hole for a tweeter. There...

Looking for suggestions for a set of 4x6's and 5.25's to go in my Mk1 Cabriolet. Currently I have some Phoenix Gold RSd460's (4x6, 5-40w RMS, 80w Peak, sens. 87dB) and RSd5's (5", 5-50w RMS, 100w Peak, sens. 88dB) The mounting style for the 4x6 is known as 4x6m. It had 4 sheet metal tabs off...

Every diagram I've seen has 1 long run of 1/0awg and distributes the power near the trunk with 2 short runs of 4awg. Is there any problem with having a single 12"-14" run of 1/0g to a fused distribution block in the engine bay, and then have two long runs of 4g to the trunk? I only ask because...