Recent content by shea2112

I did try your solution. So far so good. There doesn't appear to be an appreciable degradation in sound either. Thanks for the tip.

I do have the manuals, although the XA-300 came out several years later than the rest of the equipment. I currently have it wired up without the XDP-210 in the loop, and its working fine. I just have to determine where to place the XDP. I suppose I should just place it at the end of the chain...

Does anyone know the proper wiring configuration for a system consisting of a Sony CDX-C90, XA-300, XDP-210eq, and a CDX-828 disc changer? Of particular interest is where do the Unilink and RCA analog outputs go from the XA-300?

Thanks for the message. I'm afraid that since there is also a bit of rubber missing, that the distance needed to span the gap of the tear may be too far. I will try anything however. I once took a home audio speaker that had a similar tear into a place in Anaheim to get it fixed. This worked...

I appreciate that, but I am really trying to find either an XDP-210eq or an XDP-4000x.

i bought th only one on eBay and then promptly blew it up.

I have a torn woofer surround on my Polk SR6500 speaker. I am looking to replace this ASAP. I only need the main speaker (not the tweeter), but I will buy a pair of complete component speakers also.

Looking for a Sony XDP -4000x

I have a Sony CDX-C90 head unit that is connected by Sony Unilink cable to Sony XDP-210eq. I went over a bump and lost momentary power (presumably from a short ground wire) to the head unit. Now the the XDP-210 wont turn on. Its as if the head unit isn't sending the remote on signal throught...

I am looking for a Sony XDP-210 eq or a Sony XDP-4000X. I am very motivated to buy either of these units.