Scooby59
CarAudio.com Newbie From New Jersey
Live activity Postings About Post areas Feedback Stats
-
-
Scooby59 replied to the thread Rockville 12D1 Destroyer.my bad for the failed link but the link was for the skar big 3 upgrade. I might just keep looking around for other kits that are OFC. SKBIG3-0GA |... -
IF you can simply add the new cables to the existing setup (overlay), then 4-gauge would be fine. If you have to remove the old and replace it...
-
The first link failed; the second is all copper-clad aluminum. You will not find a 1/0 pure copper big three kit for less than about $80-$90.00.
-
Scooby59 replied to the thread Rockville 12D1 Destroyer.ok thanks for that information. i will be looking for those requirements. with that being said 1/0 would be the better route correct?
-
You want to look for any brand that is heat-tolerant, made of 100% OFC copper (not CCA copper-clad aluminum), and uses tinned pure copper lugs...
-
Scooby59 replied to the thread Rockville 12D1 Destroyer.for the big3 upgrade i was looking at this 2: https://www.lday20skaraudio.com/products/skbig3-0ga-1-0-gauge-big-3-upgrade-wiring-kit and...
-
Your Pioneer is really more like a 2.5 way, it's midrange is really too shallow and small to move enough for low midrange output, and the tweeter...
-
Scooby59 replied to the thread Rockville 12D1 Destroyer.which brand makes a good wiring upgrade kit? is skar good?
-
Scooby59 replied to the thread Rockville 12D1 Destroyer.are 2 way speakers better than a 3 way?
-
Scooby59 replied to the thread Rockville 12D1 Destroyer.ok cool i was looking into those speakers but i was not sure entirely. i did not even know i need an amp just for my speakers. i will be doing for...
-
Scooby59 replied to the thread Rockville 12D1 Destroyer.the fronts are 6x9 as well. I only replaced the rears with the pioneers, same placement as factory. Should i have them powered a different way? I...
-
What size are the front speakers? How are you going to power the fronts and the rears? What's the budget?
-
Scooby59 replied to the thread Rockville 12D1 Destroyer.Hello guy it has been a while since my last post but i wanted to give you guys an update. I went with the taramps 2k amp and a 2 gauge amp wiring...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
