Recent content by sciontistbb

I charge the locals $20 to tune their amps. $35 for two amps. Dd1 has paid itself off already. Have you tried that approach yet

I'd get the SA D4s and wire to 1 ohm. As for an amp I have this one in my ex's car pushing a single x10 Crescendo Audio Symphony S1500.1 - 1500 watts x 1 Mono Block - SSA STORE

I'd get the d4s and run a final 1 ohm load, as for your amp... What's your budget? That's if you have the electrical to run at 1 ohm.

I used to cut outside my line and lined up my walls where I needed them. Then used a flush trim bit to clean it up.

How well would a 10" IA Lethal Injection D4 do in a 4th? If so, anyone with 4th order knowledge willing to draw up a cut sheet... willing to put a reasonable amount of monies in you paypal account

Item(s) for Sale: Hertz 4 Channel HCP4 Item(s) Description/Condition: Has normal wear. Does not have end caps. Specs Hertz HCP 4 car audio amplifier 4 Ch: 65 W x 4 @ 4 Ω 4 Ch: 95 W x 4 @ 2 Ω 3 Ch: 65 W x 2 @ 4 Ω + 190 W x 1 @ 4 Ω 3 Ch: 95 W x 2 @ 2 Ω + 190 W x 1 @ 4 Ω 2 Ch: 190 W x 2 @...

ttt

$100 Shipped Lets get this sold...

Saturday night bump

Morning Bump

Yes this is my first time selling in this forum, and NO I am not out to scam anyone. No I will not ship first. I've seen how the first time sellers are treated... lol Item(s) for Sale: Hertz EP2 2 Channel, 190Watt RMS * 2 x 60W 4 ohm * 2 x 95W 2 ohm * 1 x 190W 4 ohm Item(s)...

I stand corrected, sonic has it listed as 30 x 2 fuses... looking at the actual amp spec sheet, n2 is correct.

Your amp should be mono for subs.

That amp will not see 1200 watts @ 1 ohm with 60a worth of fuses. Those hds3s take 1200 w rms and much more on clean power. You may be able to power one sub in a larger enclosure.

Not sure what you are going to splice. Cut 2 wires to length for the jumpers on each sub, connect + & - from vc1 to vc2 on each sub. Then pos to pos to amp and neg to neg to amp to achieve a final impedance of 2 ohms. Just follow the diagram. Or, instead of wires to second sub you can wire...