Recent content by s_b_801

Thats what I will do, Thanks for the reply! "boxes don't make sound" ha ha, should have seen that one coming! It was a pretty stupid reply though.

Arc Audio Kar10d Impedance : 2 or 8 ohm Resonant frequency : 28.8Hz Sensitivity : 86 db RMS power handling : 200 watts/ 400 peak Electrical "Q" : .889 Mechanical "Q" : 4.781 Total "Q" : .749 Equivalent volume: 57.26L One way linear: 8 mm Mounting depth : 5.5" Optimum sealed enclosure...

Anyone?

I adjusted one of the sample boxes to fit my application, what do you guys think? Any help would be appreciated. If this is not going to work, should I just go sealed?

I knew the old RF Punch45 could drive the low resistance but was not sure about the 60ix. Should be enough for now.

Thanks for the reply, I think I will wire it that way until I can get another amp. I don't listen that loud any more, I just want well defined bass.

I have an Arc Audio 10d dual 4 ohm voice coil sub. I want to hook this to a punch 60ix. If I bridge the two channels of the amp and run the dual voice coils in parallel, what load will the amp see? 2 ohm or 4 ohm because two channels are bridged? When I bridge two channels to a two channel...