Recent content by Ron91

Its rated at 13.8volts. My battery reads 14.1volts at idle.

I got two new 2010 CVR 10's, I've had them installed for about a week. When I had two 12" comps I was running an amp pushing 500rms between two subs. They're rated at 150rms each and they were getting about 250. They never blew and I never had any problems with them. I was wondering if its the...

I took some cauk and filled up around the wire holes. We'll see if that makes a difference. Btw, can these subs handle more than their rated power (400rms)? I've heard after you break them in a little that they can handle 500-600rms. I'm not sure if this is true. Edit- I wired it wrong...

The subs are brand new, 4 DVC Kicker CVR's in a two chamber sealed probox being pushed by a Cadence TXA1000D with 1000rms @ 1ohm. I drilled a whole through the middle of the two chambers to run wire necessary for a 1 ohm load. I seem to have a problem though... The sub on the right is flexing...

I've been around to a couple of other forums but no one seems to be offering any useful info, hopefully people here are a little more friendly. I am adding subs to my Shaker 500. I ordered a Cadence TX-A1000D, 1000rms @ 1ohm and have it installed already. I attached a pic of my amp install. I...