Recent content by rlwjr1

actually have around a 400 watt RMS amp for the mid range speakers and a 500 RMS amp for subwoofer

yeah I did use watts instead of amps I meant 100 amp breaker

Now, the breaker could be bad. I will probably just take it to the local installer. Have them do a check on the wiring . I do not have the tools to check it myself. That way I can either find out if wiring is the problem, or eliminate it if it is not the problem

Crutchfield Specs say you need a fuse or in my case a breaker around the same as the fuses in the amps. My alpine amp has 2 fuses at 30 amps each. My 4 channel amp has 2 15 amp fuses for a total of 90 , and my breaker is 100. at least according to crutchfield this is sufficient

yeah ive got the 4 gauge positive into the distribution block from battery. then 2 8 gauge going to each amp. SO I changed them around, to see if that changed the results any. I did the same with the ground wires. I did it just to see if one of the positive or ground wires were bad. I may buy a...

It does not pop the breaker most the time. The music just fades off for about 3 seconds then comes back on. But if I turn down the subwoofer on my car audio head unit. Then it never gives a problem. I even changed the ground and positive wires around to see if it would help. It did not

no just bad term from me. not hot , I should have said positive wires not hot

Bad wording, I called them hot, but I have a 4 gauge positive wire comign from batter, to distribution block , and then 8 gauge positive wire going to each amp, And 8 gauge ground wires coming from each amp . as far as brand. not sure. I had them for a while , cannot remember .

I have a 4guage hot wire going to a distribution block, with two 8 gauge hot wires going to two amps. one 8 gauge is going to a 380 watt RMS class AB Amp going to door speakers and 6 x 9s in the back. The other 8 gauge hot wire is going to a Mono block class D Alpine Amp pushing 500 watts rms...

I had a Kicker RW10CVT10. I had a Alpine MRP-M450 pushing the Subwoofer. The kicker is 400 RMS, and the Alpine at 2 Ohm is 400 watt. But, I had the gain probably around 60% of the way turned up. Twice, this kicker screwed up on me. One time it busted after having it 4 mons. I got the same...