Recent content by REVNU

Well, that sounds simple enough. I'll try that and mess the the MAGIC BLUE BUTTON. and see how that goes. Hopefully it give me my 100 watts.

When you say ONE CHANNEL, do you mean the LEFT or RIGHT channel, or FRONT or REAR channel?

According to the specs in the manual the amp is stable at: 50w x 4 @ 4 ohms Stereo 100w x 4 @ 2 ohms Stereo 200w x 2 @ 4 ohms Bridged Mono So you are correct. Problem is that the 200w is MONO, not stereo. So I need to get it to 100w @ 2 ohms without bridging, with a set of 4 ohm...

So after reading my PPI a404.2 manual I still couldn't find out if wiring up two 4-ohm Component sets will get me 2-ohms Stereo. Below is my diagram. Will that give me 2ohms from the 4-channel amp? If this helps or makes any sense, there is a button that says "FRONT/REAR" Combined". The...

FOUND THE MANAUL!!!

I know this has been covered before. I've searched but can't find how to wire my 4-Channel PPI A404.2 into 2-Channel 2x100 @ 4ohms Stereo. If that's even Possible. There's also a BLUE BUTTON (Front/Rear Combined). Not exactly sure what that will do as I have always run it at 4x50 @ 4ohms...